How to deal with broken stone joints Do you know?

First of all, clean the fractured surface of the stone, so as not to leave dust and particles, keep the fractured surface dry, not to mention moisture. If possible, use a high-pressure air pump for air pressure cleaning, remove the movable fragments, and then Coat the adhesive glue on the fractured surface, apply it evenly and not too thickly, then immediately butt and squeeze it tightly. Slightly overflow the adhesive. It should be noted that the board must be cleaned first before the glue is prepared, otherwise, the glue may become useless. For thick plates over 2cm, vertical bonding should be the best effect, that is, the stone is erected vertically after being bonded, and the weight of the stone is used to stick it firmly, and some supports can be used to put the stone upright. When bonding, use a wooden hammer or rubber hammer to gently tap the upper plate, and apply a little pressure to make the seam as small as possible. For a 1cm thick sheet, it is better to stick it flat, and spread the paper on a flat platform. , Put the stone to be bonded, and squeeze it tightly after applying glue on the fractured surface. After the glue has hardened, the next step can be carried out.

To other stone material aggranulation, wait like stone material handicraft, stone material furniture, special-shaped stone material, this process is about same.The arc plate adopts vertical bonding and the spline adopts flat bonding.In order to achieve the best adhesion without affecting the appearance, all adhesion should be as small as possible.

The bonding of parquet marble must be flat and sticky.Spread paper, preferably oily paper, on the platform so it doesn't stick, then smooth the fiberglass mesh and apply a piece of glue to the pre-assembled parquet.One piece, using a square and a tilted ruler as the base, one stick to one, squeeze one, usually bottom down, until all the pieces are glued together.In order to improve the strength of some bouquets after drying, you can evenly apply a layer of glue on the back of the bonding bouquets, and then brush gently with a brush to greatly improve the firmness of the bouquets.Of course, according to the method of parquet, for the stone material with more cracks, can also be reinforced in the back reinforcement net.Now many stone production lines have added the glass fiber reinforced mesh process after grinding, the purpose is to increase the strength of stone.