How to maintain the waterjet in winter?

The low temperature in winter has a great influence on many operations. As a device that uses water as the main medium, water jets are affected by it. However, production is still necessary, so how to make water jets in cold winter How about maintenance?

　　 We all know that the power of the water jet comes from the oil pump, and the oil pump has strict requirements on the viscosity of the hydraulic oil. Generally speaking, water jets should use anti-wear oil in winter. But as soon as the waterjet is turned on, it is basically necessary to contact the operation, and the temperature rises quickly. Therefore, the suggestion of the Rizhao waterjet sand manufacturer is: the waterjet in the area north of the Yellow River should be replaced with anti-wear hydraulic oil in winter. The water jet in the area south of the Yellow River can not be replaced, but when the machine is turned on cold, the first low-pressure operation (only the oil pump is turned on, the high pressure is not turned on) for 5 to 10 minutes, and the cutting process is performed after the noise of the oil pump is normal.

Thewaterjet is powered by a water-sand mixture mixed with waterjet sand at high speed to achieve the purpose of cutting, and the water will freeze when it is below zero, so the biggest problem of waterjet operations in winter is icing. For users north of the Yellow River, because of the low temperature, waterjet users have heat preservation methods in the factory workshop. The area south of the Yangtze River generally does not freeze or the ice period is very short, so the impact is not very large. The most strenuous is the area of the two river basins, the freezing period factory, and the user's insulation measures are not very perfect. So how can we minimize the impact of temperature on the waterjet?

The following measures can be taken to keep the water jet warm:

 1. Put on a "padded jacket" for the pump;

2. "Bake" the machine before turning it on coldly every day until there is water droplets at the end of the high-pressure pipe;

3. At the end of processing every day, remove the cutting head and store it in antifreeze;

4. Turn off the water supply of the water pump and start the oil pump to empty the water in the high-pressure cylinder, accumulator and high-pressure pipeline as much as possible;

5. The machine needs to be warmed up in advance before starting up every day, do not use it directly.