How to remove the hotel wash table face mold spot？
May 06, 2021
Protection of finished products: tidy up all toiletries on the counter, and check whether the faucet, basin and countertop are damaged;During the construction process, put the floor mat on the door and put on the shoe cover.
2. Cutting and blocking: guests are not allowed to stay in the mildew treatment room temporarily, so as to ensure that the wash table surface is clean and dry during the mildew treatment.
3. Dry grinding cleaning: first use No. 0 dry grinding plate to rough grinding to open the stone surface. Where the portable polishing machine can not grind to, use coarse sand paper to manually open the stone surface, so that the water vapor inside the stone can be emitted.
4.Measurement of humidity: use moisture meter to measure the humidity of the table, less than 10% can be constructed.
5 To the case: the first stone demildew decolorizing agent paste on the surface of the stone, and then use a clean brush light pressure paste agent place.The application of the agent can not bulge, there is rust yellow place with rust remover for application, such as agent reaction 2-4 hours later, observe the stone is polluted place is handled clean.If not clean, apply again.
6. Remove the liquid: remove the residual agent on the table with stone soap solution or clear water after treating the mildew.
7. Brushing protection: after the stone is cleaned and dried, the stone protective agent is applied to effectively control the generation of mildew in the later use.
8. Finally, according to the general process of stone care, sequential grinding, polishing and other procedures, so that the stone to restore the original gloss and decorative effect.
