Prevention of stone disease in toilet

1 Protection:

Before installation, the stone material should be protected on six sides.The six sides are the surface, the bottom and the four sides.Among them, the bottom surface should be bonded with the floor surface. In order to avoid the influence of ordinary protective agent on adhesion, so the protection of the stone bottom surface should be used with special "stone bottom protective agent".

The use of VD stone bottom protective agent, VD penetration stone protective agent, stone for 2~3 times of protection treatment.

Protection construction standard: sufficient, uniform, health preservation for more than 24 hours.

2 Shop:

Toolroom stone pavement replaces cement with adhesive, in the environment of much water, cement will cause stone to return alkali baihua, and the use of adhesive can avoid the vast majority of problems caused by water.

4 Physical polishing + sealing glaze:

The use of physical grinding way, grinding out the luster of the stone itself, physical gloss of its own super wear-resistant, coupled with the hard and compact, insoluble silica protective layer, can ensure that the stone in the toilet such a watery environment is still maintained for a long time beautiful effect.

3. Close assembly installation:

Toilet stone installation, do not reserve gaps, but to use the installation of dense.Installation, to the four sides of the stone, coated with high-quality marble glue, and then force the stone joint squeeze, the narrower the gap is better.

Stone corner position and joint position with the wall with glue repair, toilet glue is recommended to use porcelain glue, porcelain glue is smooth and waterproof, to avoid the use of glass glue moldy situation