Ten matters needing attention in the use of stone binder
Jul 11, 2021
1, The water mixing binder must use clear water (such as: clean tap water):
2, The preparation of adhesive process, shall not add other materials and admixtures
3. The adjusted slurry should be used up within 2 hours:
4, Stone bonding surface before bonding should not be used ordinary protective agent to do protective treatment, otherwise easy to cause falling off the recommended use of AD2009 waterproof gum, can prevent falling off and waterproof, baihua.
5, The construction temperature can not be lower than 5℃, winter can be properly heated to improve the temperature of the board
6, The stone surface with chemical substances or oil should be cleaned, and keep its dry.
7, Glue now with now, the amount of glue adjustment should not be too much;If the temperature is low, the amount of glue adjustment is small, the use time and curing time is long;On the contrary, the curing time is short
8. Do not mix the glue tools, do not put the remaining glue back into the original package after mixing, and do not move the plate when the glue is not fully solidified.
9. In winter, if the viscosity of the glue is large, the glue (A) can also be placed in A 40-80℃ water bath and heated to reduce the viscosity, but after heating, it must be cooled to below 40 degrees and then the curing agent (B) can be added.
10, The surface coated after extruding excess glue, before solidification can continue to be used on other stone.
11. Because of the different physical and chemical properties of the stone, please try it in advance to avoid mistakes.Do not mix the cover cover, with the back cover tightly, do not enter!
12, Adjust the glue to promote the principle of how much with how much.Now is used, and must be used up within the usable time, the more ingredients or construction temperature, the shorter the use time.
