Analyze the causes and measures of three common faults in stone design

Cause analysis,

1. The planning and drawing deepening is not in place, and the size of the order is deviated.

2,Not to shift to the right technical clarificaiton, installation order.

preventive measure

1. Deepening drawings should be in place, and details should be taken into account.

2, When placing an order, consider to achieve smooth hair surface.Install the light panel at the closing place of the wool surface stone first, and then install the concave and convex surface (wool surface) stone.Also pay attention to the control of verticality, flatness and dimensional deviation.

Also can consider to leave concave and convex surface (or wool surface) stone left to do cutting groove.

◆ Common phenomenon 2: black seam in the closed slot stone

Cause analysis,

1, The single size of the slot plate is not accurate;

2, Site workers construction installation is not in place, not cut well;

preventive measure

1. When placing an order, the management personnel should conduct on-site review, first carry out accurate wiring, and then place an order accurately according to the actual size of the stone, so as to make the size of the order precise.

2, The length of stainless steel processing can be appropriately lengthened, in the field of corner cutting, to avoid the stone construction space is not square caused by the shortage of stainless steel length.

3, In deepening the closing place to leave the process groove, the closing place of the slot plate to make a plane, the size should be unified.The stainless steel edge should be 2-3 mm higher than the stone to ensure a perfect closing.

Common phenomenon three: wall marble texture messy