Inventory of quartz stone splicing skills

Stone conservation to understand the quartz stone plate because of its own antibacterial, high temperature resistance, wear resistance, leakage prevention, non-toxic, no radiation and other advantages, is included in the national green decoration stone, is recognized by more people and is used with the cabinet table.But in the specific application of decoration, can not avoid two pieces of splicing or even more pieces of splicing, because the quartz stone plate hardness is as high as mohs hardness 7, splicing, in order to make the whole look like one integrated whole, test the quartz stone manufacturers and processing master technology.How to achieve seamless stitching this is a major technological breakthrough in the pursuit of perfection.

For quartz stone processing industry, its plate hardness is second only to the hardness of diamond, almost harsh raw material ratio, coupled with technical limitations, quartz stone itself because the hardness is too high, plus the inside of the particles will collapse edge, so the opening of the edge is rough, natural splicing will produce a gap.Seamless stitching is more difficult.Even if quartz stone can do seamless stitching, but after grinding and polishing can not be processed with the original, there will still be the emergence of stitching glue line, which has nothing to do with the price of quartz stone, not the high price can do it.

At present, in order to achieve quartz stone seamless stitching, the first requirement for processing equipment is very high, and the following with small make up to understand the detailed steps!

1, The need to use the water knife for the joint diagonal cutting (45° hypotenuse is the best) splicing, currently in the Chinese market has numerical control water knife cutting machine, has been used by large table processors

2, After completion, use the original manufacturer with the same color resin glue to paste, do not use other glue (can do seamless stitching and glue is inseparable).

Tips: Before pasting, the color should be opposite the plate to avoid color difference, and the paper tape should be used to paste the edge of the two pairs of interfaces.In order to avoid glue contact with the surface of the plate, there will be unnecessary trouble when cleaning.

3. Evenly smear the glue on the splicing mouth, and use the F clip to fix it for about 20 minutes (the hydraulic sucker supercharger can be used if conditions permit).

4. Use a water mill to polish the joints.