Method for laying cement mortar on stone ground wall surface

Jul 19, 2020

Method for laying cement mortar on stone ground wall surface

 

Cement mortar installation ground: The construction site should be cleaned up before the construction of the stone ground, to prevent cross-operation of other processes, and check the specifications and quality of the stone. On-site trial arrangement and test, the stones are sorted and stacked, and the water is soaked and dried. The construction process is: cleaning, bouncing, paving, grouting, and protection.

1

1. For structural inspection, before construction, check the foundation according to the requirements of the drawings. The construction must be within the allowable deviation range of the foundation. For example, the flatness of the ground, combined with the elevation requirements, check whether the thickness of the cement mortar layer meets the requirements. Site cleaning; check whether the original base layer has a hollow drum; cut out the higher part of the base layer, repair the concave part, and make cement sand leveling layer if necessary; water the site at the site one day in advance to wet the construction base layer.

 

2. The establishment of the baseline, determine the horizontal elevation, establish a contour point on each reference point, and mark the baseline. Check whether the reference line is correct, check the layout of the stone blanking layout, and check with the site. According to the design requirements, combined with the characteristics of the construction surface, determine the construction direction sequence.

 

3. Moisten the substrate. Before installation, the ground must be cleaned, and the substrate should be moistened with clean water.

 

4. Apply cement slurry. After the foundation is wetted, begin to apply cement slurry on the ground, the purpose is to improve the adhesion.

 

5. Paste the base layer, cement is 425 cement, and sand is medium-heavy river sand. Cement mortar is prepared according to the ratio of 1:3, and it is appropriate to grasp the humidity of the water just by hand.

 

6. Board installation, (the problem of going to the net on the ground and the back of the stone wall, and the problem of water jet parquet and fragile net)

2

You Might Also Like