Three methods of wall stone installation

The common method of wall stone installation is wet pasting. In recent years, there has been a method of dry hanging pavement. In addition to these two more common methods, there is a direct paste method.

   One is dry hanging. Fix it on the wall with bolts first. Then groove a piece of stone, fix the stone with a T-shaped frame, and then fix the T-shaped frame and the bolt together, such a marble wall has a certain distance from the wall itself, but the fixability is good.

   The second is wet stickers. It is necessary to lay a layer of steel mesh on the wall first, and then use the concrete wet paste.

   The third is to paste directly. Generally divided into point paste and face paste. The surface sticking method is suitable for thin stone, the thickness is below 8MM, the weight is similar to the wall tiles, and it can be pasted with special mortar. The point paste is made of special glue for stone. The range of the point can not be greater than 25CM, the amount of the point cannot be less than 3-4CM, and the thickness of the glue is more than 0.5CM. This method is used for slightly thicker stone.

   The direct paste method is not suitable for toilets, because the toilets are mainly based on light-weight walls, and the degree of deformation is large, and the toilets are often wet for a long time. The glue is easy to age and accidents are easy to happen.

   Direct paste is also very important for the wall surface. First, if there is putty on the concrete wall, you must first shovel the putty and paste it directly on the concrete wall. In addition, due to the large degree of deformation of the light-weight wall, if the wall is deformed after viscose, the stone will also change, causing hidden dangers.