How To Clean The Stone In The Bathroom Space?

Solution one

　　 It is recommended to use stone-specific products, such as a strong concentrated cleaning agent, with a pH of about 10.5. This type of product can decompose the organic pollution on the stone surface and remove the surface protective agent. If necessary, the cleaning agent can be mixed with the detergent powder, which can extend the reaction time of the compound and absorb the stain into the paste. Before using the compound, test a small area such as a corner of a wall that is not conspicuous, and make sure that the stone surface will not be covered with dark flower marks. It is relatively easy to remove minor scratches, and there are many polishing powders on the market. However, when using polishing powder, it is usually necessary to use a polishing machine or a single wiper.

Solution two

　　 It is recommended to use liquid medicine, preferably a two-component enzyme cleaning agent, which can penetrate into the bottom of the stone and filter dirt and dust to the surface. Enzymes are especially effective on vegetable stains. Such cleaning agents can be purchased from agents of high-quality stone cleaning agents.

　　 If the effect of using this method is still not obvious, it is recommended to mix the solution of the enzyme cleaner with the decontamination powder until a viscous ointment similar to peanut butter is formed. Apply the mixed ointment to the contaminated area, cover it with plastic film, and seal the surrounding area with tape. Maintain a reaction time of 24 to 72 hours, and then use a small bamboo plank to scrape off the dried ointment. If necessary, do it again. Once the contamination is removed, it is recommended to protect the stone with a permeable protective agent to avoid contamination again in the future.

　　 If the stained marble surface has scratches at the same time, it needs to be polished. The choice of grinding powder needs to be determined by the construction party, which may be brick soil, cinder, sandpaper or emery. The process may be more complicated, so it is recommended to be handled by professionals. It should be clear that for some 305X305X10mm sheets, the damage from high-heeled shoes may also penetrate deep into the stone, which may be difficult or almost impossible to polish. In this case, it is best to seek expert assistance.

Solution three

Regarding the stains on the stone around the bathtub and the edge of the window sill, the problem should be that these marbles have never been protected or improperly maintained. Since mild cleaning agents are not effective, we recommend using a neutral cleaning agent mixed with powder to form a slurry-like viscous mixture, applying the paste to the stone surface, and then rubbing it with a nylon pad. The powder acts like an abrasive and helps remove stubborn stains on the surface. If this method does not work, it is recommended to mix alkaline cleaning agent with clay powder to form a strong cleaning agent solution. The rest of the operation procedures are as described above.

Speaking of scratches on the ground, it is recommended that professionals come to the site to inspect and polish the marble surface again. Since re-polishing usually requires the use of liquid or powdered products, or emery polishing pads, it is best to ask professionals to operate. You can check with local stone manufacturers or distributors, and ask them to recommend more well-known stone maintenance products and treat them professionally.