How To Stone Protection？

Stone protection

Stone inlaid with copper strips must be well protected. Especially the high water absorption rate of marble, but also the need for the highest level of protection. That is, the use of high quality osmotic protective agent or fluoride protective agent, do more than brushing processing. In the gap should also increase the number of times.

Handle carefully after grinding

When the floor is refurbished, if the copper strip can be ground and has been ground. Then the fine copper particles that are ground out are stuck in the area of the gap twice.

Therefore, be sure to use a high-power pumping machine along the ground copper strip, pumping several times, the water slurry thoroughly clean up. This sucks away tiny particles of copper that we can't see or see. Can prevent or mitigate subsequent complex changes.

So it doesn't have any effect on the copper itself. Complex chemical changes can occur. It can avoid the phenomenon of green and black caused by copper strip.

Polish with seal glaze instead of crystal

Because the crystallization technology itself is built on the basis of "acid etching". Crystallization technology has evolved over the years, and a variety of brands have emerged that use different ingredients but share the same basic principles.

Therefore, there is no crystalline material without acidic composition. That is to say, the marble floor inlaid with copper strips, polished with crystallization technology, there is always a potential contamination of copper compounds.

So, this kind of ground, want to polish with seal glaze technology. The principle of sealing glaze technology is to apply the silica (SiO2) component extracted from natural quartz ore to the stone surface. Crystallization technology is chemical action, glaze sealing technology is physical application.

So it doesn't have any effect on the copper itself. Complex chemical changes can occur. It can avoid the phenomenon of green and black caused by copper strip.