Composition And Installation Steps Of Stone Roman Columns

In the special-shaped stone craft, the stone Roman column is also a widely used material, and it has different shapes in hotels and private mansions.

  Stone Roman column generally refers to a special-shaped column with several grooves processed in the direction of the generatrix on the outer surface of the cylinder. The groove on the Roman column is generally not connected and penetrated near the column base and column cap. Depending on the height of the column, the Roman column can be a monolithic column made of a whole stone, or a column formed by splicing several sections of the column with the column base and the column cap.

The diameter and height of the cylinder mainly depend on the size of the block. The diameter ranges from 100mm to 2000mm. There may be 5000mm for special requirements. The standard includes three parts: column foundation, column body and column cap.

Stone Roman column processing steps:

  Cylinder grinding and polishing processing. Generally, it is performed on a lathe equipped with a pneumatic or hydraulic pressure grinding head, and the abrasive installed on the grinding head can be quickly replaced. However, due to the large fluctuations in the contour lines of railing posts, vases and other products, it is difficult to grind and polish using the above-mentioned ring-shaped abrasives. Therefore, simple grinding and polishing equipment that manually grinds special-shaped revolvers is still used to complete the polishing of railing posts and other products. Processing.

  End face trimming. After the polishing of the stone cylinder is finished, the two end faces of the cylinder can be cut with a diamond saw blade to make the length meet the requirements of the finished product. It should be noted that the angle between the cut end face and its axis should be slightly less than 90 degrees, so that during installation, the seam can be smaller and achieve a beautiful effect.

  Cylinder cleaning, inspection and packaging. After the processed cylinder is cleaned, inspected and dried, it is packaged. When packaging, first wrap the cylinder with a plastic film, and then fix it with a wooden fence. The cylinder is placed and damaged by collision.