Three Ways To Install And Seal Stone !

1. No sealant is added to the gap, and air convection is formed on the back of the stone to discharge water vapor to deposit and prevent the temperature difference on the surface of the stone so that the internal surface of the stone will not be condensed.

2. The semi-sealed sealing type is to keep the facade without sealant. The facade has a good three-dimensional effect. In fact, the glue layer is hidden inside the interconnection, but the thickness of the sealant should be about 6mm. , But it cannot exceed the width, and its width should be calculated based on the quality of the glue. It shall be consistent with the relevant regulations of JGJ120 and JGJ133.

3. Use neutral sealing silicone glue, which is a special glue for stone, seals all the gaps on the facade, and the rain on the facade cannot enter the back of the stone, so that the stone is in a tight and dry state. Rain, except snow, ensure It is necessary to ensure that the stone does not freeze or alkalize, and to ensure the permanence of the project.

In addition, when sealing the stone, there must be a consciousness. Although the stone cannot breathe like a human, it also needs to be "breathable". The stone is composed of various crystals, and the crystals are composed of various minerals. The crystal structure formed by the material determines whether the stone is marble, limestone, or limestone. The water in the stone also needs to evaporate to the outside through the gap.