Six steps of stone seamless treatment construction process

1. Clean up the original fillers in the stone gaps first, and then use a special stone slitting machine to neatly cut and slit the center gaps of the original stone installations to minimize the width difference of the gaps between the stones. The colored marble glue fills it in. (Note: If the center seam has been done before, there is no need to re-sew).

2. Use marble glue close to the color of the stone itself and perfect the color of the marble glue to make it fully close to the original stone color to improve the overall feeling and achieve the most ideal visual effect.

3. Fill the adjusted marble glue. Since the marble glue will shrink to a certain extent after it is completely solidified, the marble glue should be slightly higher than the stone level, so that it will not be filled multiple times.

4. Use polishing pads and polishing fillers to make it become a horizontal surface with the stone, increase the overall sense of the stone, and solve the problem of height between the gaps and prevent the gaps from turning black again. Use a granite refurbishing machine with a special cutting edge grinding sheet to carefully polish the cutting edge to make it a flat surface with the stone.

5. Grinding and polishing: Use a special granite polishing machine to grind the stone from coarse to fine stone from the 50-3000 size, so that the ground is bright and smooth as new.

6. Crystallization treatment: Use stone crystal powder and crystal agent to polish with crystal surface grinder. Under the weight of grinding, the stone and crystal powder will undergo a comprehensive physical and chemical reaction under the action of high temperature to form a dense and hard crystal protective layer. . After crystallization, it can enhance the color and brightness, and can also achieve anti-skid, waterproof, oil-proof and other effects.